0 item
1600 Watt Missouri Falcon 62 Inch 5 Blade Freedom Wind Turbine

453.99 453.99 USD


This combination does not exist.

Category: Wind Products

Features the superior quality and performance of the Freedom 1600 Watt PMG -
with our 62 Inch Missouri Falcon Aluminum Blades!

The Missouri Wind and Solar Freedom PMGs contain more copper than typical wind turbine alternators and generators on the market. What does that mean? More copper equals more power output! Our custom made skewed stator reduces cogging and allows startup in lower wind speeds.

Wind Turbine Features:

  • Comes with Five Missouri Falcon 62" Diameter Blades
    • .125" thick aircraft aluminum with manganese for added strength
    • Each blade is 29.5 inches long
    • Blade width is 6.5 inches (16.51 cm) wide
    • Assembled blades and hub makes 62 inch swept area
    • Zinc plated steel hub is 1/4 inch thick
  • External 3 phase bridge rectifier for converting to DC output
  • Heavy duty hub spacer/stabilizer with slot to fit keyway so blades stay securely in place
  • PMG mounting bracket and heavy-duty Stars & Stripes wind turbine tail
    • Mounting Bracket fits on 1.5" schedule #40 or #80 pipe (1 7/8" OD) and allows for easy turning
    • Tail fin measures 9 3/4 inches wide x 28 3/4 inches tall
      • Cut from 16 gauge steel
    • Hot dipped galvanized weather resistant finish
    • Overall length from blades to tail is 37 inches

Simple and effective, the turbine uses a wire tension system which will last a lifetime. The single power transmission cord never twists because the wind never spins the turbine around in the same direction hundreds of times.

Typically, the wind only comes from two directions. It has yet to be an issue with any one of the thousands of turbines we have distributed.

Freedom PMG Features:

  • Available in 12 Volts, 24 Volts, and 48 Volts
  • 17 mm stainless steel shaft compatible with all Missouri Wind and Solar hubs and blade sets
  • Custom hub spacer/stabilizer with keyway and bolts for attaching to Missouri Wind and Solar blade hubs
  • Zinc plated 14 rare earth neodymium magnet rotor
  • No brushes to fail or replace
  • Large, heavy-duty bearings in front and back
  • Fits delco bolt patterns and mounts up to our standard mounting bracket
  • 3/8" Diameter bolt holes
  • 1 15/16" on center between mounting holes
  • 5 7/8" OD Width
  • 6 5/16" Tall
  • 10 pounds

Freedom 3 Sealed PMG™ Features:

  • Available in 12 Volts

  • The NEW Missouri Wind and Solar Freedom 3 PMG is fully sealed to create a water and dust resistant motor for wind power. Truly well thought out with years of R&D behind the production.

  • Larger bearing to withstand wear and abuse

  • Case with a rough, natural finish which means more surface area to speed cooling and improve output performance

  • Keyed shaft and hub stabilizer that bolts on to the blade hub to prevent slipping and improve safety

  • Hub stabilizer that channels water away from entering through the front of the housing

  • Gasket style seal to keep water from seeping into the case

  • Water and dust resistant design - no marine varnish or painting required

  • Wind tunnel tested up to 55 MPH


PMA and PMG cases should not be painted or coated - this prevents heat from leaving the motor and reduces efficiency. If you have an open-faced motor like our Freedom single and dual PMGs, you can marine varnish the interior components.

Freedom 3 Sealed Motor Features:

Missouri Wind and Solar Basic Setup Diagram
You can compare max 4 products.