0 item
Hybrid All In One Digital Charge Controller Board with DC to AC Inverter

593.99 593.99 USD


This combination does not exist.

All In One Digital Charge Controller Board 

for Wind Turbines and Solar Panels


Each Model Includes:

12 Volt All in One Charge Controller Board 24 Volt All in One Charge Controller Board
Charge Controller 12/24 Volt Digital Charge Controller Unit
(See below for specification)
Brake Switch 3 Phase Brake Switch
Dump/Divert Load 600 Watt Divert Load Resistor Bank

12 Volt 2000 Watt DC to AC modified inverter by Aims

  • PWRINV200012
  • Continuous output power: 2000 Watts
  • Surge power capability (peak power): 4000 Watts
  • 3 AC receptacles (UL rated 1500 watts max per an outlet)
  • DC input / operating voltage: 10 to 16 Volts
  • Output voltage: 120 Volts AC +/- 10%
  • Volt meter & watt meter on front panel

24 Volt 2500 Watt modified inverter by Aims

  • PWRINV250024W
  • Continuous output power: 2500 Watts.
  • Surge power capability (peak power): 5000 Watts
  • Dual AC receptacle with protective rubber covers
  • DC input / operating voltage: 20 to 30 Volts
  • Output voltage: 120 Volts AC +/- 10%
  • Volt meter & watt meter on front panel

FuseFuse with ANE Fuse BlockFuse with ANE Fuse Block

Product Weight & Dimensions:

  • Product Dimensions: 24 x 18 x 4.25 inches
  • Product Weight: 19.2 pounds

Designed, assembled and quality checked in Missouri USA using global parts.

12 / 24 Volt Digital Charge Controller

Built in digital display and intelligent dual processor controller

Some of the key features of the hybrid controller are:

  • Dual (2) Microprocessor controlled - Very stable and very accurate
  • Multiple user changeable settings and trip points for many various system requirements and applications
    • You can change the dump point voltage level, end of dump voltage level, length of time in divert mode when end dump point voltage is reached (between 0 to 999 seconds, or 0 to 999 minutes)
    • The controller will also monitor the diversion/disconnect activity and increase its duration several times when your batteries are full. This feature is also adjustable. 
  • Isolated Electronics Protection - Almost impossible to accidentally connect wind or solar directly to the circuit board.
  • High amp rating - 440 amps, 10,000 watts.
  • Battery Status LED - Lets you know your battery's actual voltage!
    • Green LED on board lets you know it's in dump mode
  • Plug & Play - Long leads for easy termination to your 12 volt or 24 volt battery or battery bank.
  • Dump or Divert - Can divert the charging source from the batteries to the load, or dump both the batteries along with the charging source.
  • Hybrid Capability - You can connect both wind and solar at the same time
  • Reverse polarity protection
  • Ultra low power consumption even with the voltmeter on (almost negligible). You can even set the voltmeter to turn off after inactivity.
  • Comes completely pre-wired as shown above.

You can compare max 4 products.