This new Renegade 800 Watt plus 3-phase AC to DC output seven N45 permanent magnet 14 pole alternator is made in the USA by Missouri Wind and Solar. These are the same pma's that we use on our 800 watt wind turbines.

New three phase AC output allows you to make your run of 3 conductor single power cable more cost effective and efficient. With a wide range of voltage outputs you can achieve your power needs in any wind situation or system voltage including battery charging, and/or grid tie feed inverters.

This completely assembled PMA (pictured top left of collage) comes with a high output rectifier, rotor, and perfectly matched high output stator combination. We can produce 10 times more power than an air tight sealed pma design in part because of the open faced air cooling and special rotor cooling vents. More wind equals more cooling. Make sure to attach our high output fan and pulley if it's not being used as a wind turbine motor. This is important to help keep it cool when air is not being forced through the PMA. On its first run make sure to adjust your RPMs if your PMA becomes too hot. If you're using it for a vertical axis wind turbine the proper fan and pulley is required for proper cooling.
This pma makes power turning in either direction.
Weather resistant interior finishes can be left untouched for a lifetime without additional coatings or varnishes. And with no electronics or rectifier in the pma there is nothing to ever go bad or replace. We're proud of the simple and tough design. If you have any questions about where to install the pma don't hesitate to contact us. Note: rain water does not damage or disrupt our permanent magnet alternators operation. If you live near salt water or in very dusty or severe climates use our "Permanent Magnet Alternator Wind Turbine PMA Coating" for extra protection on the pma and anything else you need a high quality durable finish on.



Please choose between 12 volt, 24 volt, or 48 volt before checkout.


The picture collage below shows various angles of our new design.