The kit comes with wind turbine brake switch, bridge rectifier and heavy duty electrogalvanized steel recessed back plate all pre-wired and ready to go! This 50 amp, 3-phase brake switch with short circuit break works with 12 Volt to 250 Volt systems.

Designed for 1250 watt and smaller turbines. The simple yet perfect design is ideal for small turbine installations.

This 3-phase switch uses a specialized 3 pole, 3 throw switch (3P3T) to provide both disconnect capability as well as breaking by shorting out the 3 wires of the stator.

Although designed specifically for 3-phase turbines, it works equally as well for single phase AC turbines as well as DC turbines.

This switch will handle 2500 watts continuously. Rated at 10A at 250 Volts, 15A at 125v, 25A at 60v, 40A at 30V and 50A at 15V.

Rectifier Specifications:
Good cooling capabilities - can handle 90 Amps continuously using air cooling, no fan.
Works on all AC output wind turbines that produce 90 Amps or less
Operating range is 0 to 1000 Volts
Note: Use self tapping screws or the spade terminals to connect your wires.

Please see the additional pictures below for helpful diagrams.